Using Hyperterminal For Telnet Remote Control Operation - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710/L Broadcast Satellite Modem
Ethernet Interface Operation
The CDM-710/L Broadcast Satellite Modem provides a Telnet interface for two
primary functions:
• Equipment M&C via the standard equipment Remote Control protocol.
• Equipment M&C via the Comtech Monitor and Control System (CMCS)
application.
Telnet is implemented in the CDM-710/L Ethernet M&C in a "Telnet wrapper".
When the user Telnets to the unit, it emulates a local EIA-232 or EIA-485 serial
connection. You can then type the same command syntax that he would use
from a serial remote terminal and the Ethernet M&C "unwraps" the Telnet
packet and sends it on to the base unit processor, which responds to it as if it
was a serial remote command.
The Telnet interface requires user login at the Administrator level and
Read/Write level. Once logged into the Telnet interface as the Administrator, you
have access to the optional serial-based Remote Control Interface. Figure 8-1
shows an example of the login process and remote control operation.
8.3.1 Using HyperTerminal for Telnet Remote Control
Operation
Figure 8-2. Telnet Interface Example – HyperTerminal
8–7
MN/CDM710.IOM
Revision 12