Modem Connections; Configure The Terminal Emulator Program - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710/L Broadcast Satellite Modem
Firmware Update

5.2.1.1 Modem Connections

Connect the User PC to the modem:
• Use the 9-pin serial cable to connect the modem 'P2 | Remote' port to a
serial port on the User PC.
• Use an Ethernet hub, switch, or direct cable connection to connect the
modem 'J4 | Ethernet' port to the Ethernet port on the User PC.
BASE MODEM firmware can only be loaded via the 'J4 | Ethernet' M&C
port; do not use the Ethernet Traffic port available on the CDI-70 Data
Interface Module.
5.2.2

Configure the Terminal Emulator Program

On the User PC – Open the terminal emulator program, and then configure the
program's serial port communication and terminal display operation:
• Baud Rate = 38400 bps
• Data Bits = 8
• Stop bits = 1
• Parity = NO
• Local Echo = ON
• Port Flow Control = NONE
• Display New Line Rx/Tx = CR
Read your terminal emulator program user guide or HELP feature for
operating and configuration instructions.
5–3
MN/CDM710.IOM
Revision 12