Comtech EF Data CDM-710 Installation And Operation Manual page 146

CDM-710/L Broadcast Satellite Modem
Front Panel Operation
(CONFIG:) Intfc2 Gigabit Ethernet: IngressStrIP1/2Group
Where # is the selected stream (1 or 2): To enter the Group Multicast IP Address,
first use the ◄ ► arrow keys to select the digit, and then use the ▲ ▼ arrow
keys to change that digit. Press ENTER.
(CONFIG:) Intfc2 Gigabit Ethernet: IngressStrIP1/2Source
Where # is the selected stream (1 or 2): To enter the Source Multicast IP Address,
first use the ◄ ► arrow keys to select the digit, and then use the ▲ ▼ arrow
keys to change that digit. Press ENTER.
(CONFIG:) Intfc2 Gigabit Ethernet:  Ingress  Str  IP  Port
To enter the Destination UDP port for ingress streams, first use the ◄ ► arrow
keys to select the digit, and then use the ▲▼ arrow keys to change that digit.
Press ENTER.
(CONFIG:) Intfc2 Gigabit Ethernet:  Ingress  Str  Mode
Use the   arrow keys to select Single or Dual. Select Single if one IP
connection carrying an MPEG-2 transport stream is present, or if automatic
redundancy switching is disabled. Select Dual for redundancy operation with
dual IP connections, each transporting an MPEG-2 transport stream, and
automatic switching between the two streams is performed. Press ENTER.
Intfc2 Multicast #
224.001.001.002
Intfc2 Source IP #
224.001.001.002
Intfc2 UDP Port
05060
Intfc2 Multicast Mode
Single Dual
7–40
MN/CDM710.IOM


Revision 12