Comtech EF Data CDM-710 Installation And Operation Manual page 119

CDM-710/L Broadcast Satellite Modem
Front Panel Operation
(Config:) Remote Control: EthernetSNMPCommunityWrite
Edit the SNMP Write Community string. Use the   arrow keys to select a
character, and then use the  arrow keys to change that character. All
printable ASCII characters are available, except for the backslash (ASCII code 92)
and tilde ~ (ASCII code 126).
Press ENTER after you compose the string. The unit removes all trailing spaces
from the string upon entry.
(Config:) Remote Control:  Ethernet  SNMP 
Use the   arrow keys to select IP1, IP2, or Version. Press ENTER.
(Config:) Remote Control: EthernetSNMP
Edit the #1 or #2 IP Address. Use the   arrow keys to select a digit, and then
use the  arrow keys to change that digit. Press ENTER. You may disable
SNMP Traps by setting both Trap IP Addresses as 000.000.000.000.
(Config:) Remote Control:  Ethernet  SNMP 
Use the   arrow keys to select SNMPv1 or SNMPv2. Press ENTER.
Write Community:
private
SNMP Trap IP Address:
IP1 IP2 Version
Trap ID #X:
000.000.000.000
Trap Version:
SNMPv1 SNMPv2
7–13
MN/CDM710.IOM
(E)
Traps
Traps
IP1 or IP2
(E)
Traps
 Version
(E)
Revision 12