CDM-710/L Broadcast Satellite Modem
Front Panel Operation
(Config:) Intfc1 HSSI: Rx Enable
Use the arrow keys to select Enable to activate the Rx side of this interface,
or Disable to de-activate the Rx side and set the Data Rate to 0. Press ENTER.
(Config:) Intfc1 HSSI: CTS/RTS
Use the arrow keys to select Normal or Fault. Press ENTER.
Note that CTS is the same as CA, and RTS is the same as TA. Additionally:
• Normal: CTS = RTS
• Fault: CTS = RTS when no fault is present. CTS is not asserted when a fault
is present.
Intfc1 Rx Enable:
Enable Disable
Intfc1 CTS/RTS:
Normal Fault
7–37
MN/CDM710.IOM
Revision 12
(E)