CDM-710/L Broadcast Satellite Modem
Front Panel Operation
Use the
arrow keys to select operation as Pre-EQ or Post-Eq. Press ENTER.
(Config:) Rx: Dem Pilot (DVB-S2 Mode only)
This screen displays a read-only status message. The demodulator
automatically determines whether Pilots are ON or OFF.
Unlike the (Config:) Tx: ModPilot screen, Off and On are not selectable on
this read-only screen. A solid bar indicates the operating state. Press ENTER or
CLEAR to return to the previous menu.
(Config:) Rx: Dem Scr (Descrambler) (DVB-S2 Mode only)
The Gold-n Index indicates the Physical Layer spreading sequence number. It can
be set from 000000 to 262,141. The default setting is all 0s.
Use the arrow keys to select the digit, and then use the arrow keys to
change that digit. Press ENTER.
(Config:) Rx: Code
1) In DVB-S2 mode, this screen displays a read-only status message. The
demodulator automatically resolves the Code Rate.
2) All possible choices are displayed. The cursor only lands on valid
code rates depending upon the active mode and purchased FAST
options.
Rx Demodulation Pilot:
Off On
Rx Descrambling Index:
Gold-n = 000000
Code Rate: 1/2 3/5 2/3
3/4 4/5 5/6 7/8 8/9 9/10
7–27
MN/CDM710.IOM
(E)
(▲ ▼E)
Revision 12