CDM-710/L Broadcast Satellite Modem
Front Panel Operation
(Config:) Aux (Redundancy): Ena/Dis
The solid cursor indicates the current configuration choice. Use the
keys to select Enable or Disable. Note that:
• "Enable" sets up the unit for operation with the 1:1 IF switch. An internal
auxiliary relay sets the 'P2 | Alarms' connector for the 1:1 operation
mode.
• You may select "Disable" only when the unit is in "Local" mode. If you
attempt to select "Disable" while the unit is in "Remote" mode, the
following message displays:
Follow the prompts. Press ENTER to change to "Local" mode. Press CLEAR to
remain in "Remote" mode.
When 1:1 redundancy operation is selected, J5 becomes the active
port – J4 is not available. For 1:N redundancy operation, either J4 or J5
is available.
(Config:) Aux (Redundancy) Force (1:1)
Press ENTER to initiate switchover. You may only use Force (1:1) with a 1:1
switch to force switchover, and only from the modem that is currently "Online."
(The online modem is indicated by the "ONLINE" LED on the modem front
panel.)
Redundancy Mode:
Enable Disable
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
DO YOU WANT LOCAL MODE?
ENT=Yes CLR=No
Press ENT To Force Modem
To Standby (1:1 only)
7–49
MN/CDM710.IOM
Revision 12
(E)
arrow