Toyota Avensis ZZT251 2003 Service And Repair Manual page 1771

Protective
Tape
Cushion Rubber
: Clip
Claw A
1
2
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE HOOD/DOOR
4.
(a)
HINT:
Tape the screwdriver tip before use.
(b)
(c)
B70388
5.
Protective
(a)
Tape
(b)
(c)
Screw
(d)
(e)
HINT:
In order to prevent the door panel from being damaged, cover
the areas indicated by the arrow marks in the illustration with
protective tape.
(f)
Bolt
B66971
6.
(a)
B70121
7.
(a)
HINT:
Tape the screwdriver tip before use.
(b)
(c)
: Claw
B68930
http://vnx.su
– FRONT DOOR
REMOVE POWER WINDOW REGULATOR MASTER
SWITCH ASSY
Using a screwdriver, disengage the 4 claws and clip, and
remove the armrest base panel upper together with the
switch.
Disconnect the switch connector.
Remove the 3 screws and switch from the armrest base
panel upper.
REMOVE FRONT DOOR TRIM BOARD SUB–ASSY LH
Disconnect the courtesy lamp connector.
Remove the 3 cushion rubbers.
Remove the 2 screws and bolt as indicated.
Using a clip remover, disengage 9 clips.
Remove the trim board upward.
Disengage the 2 claws and remove the courtesy lamp.
REMOVE FRONT DOOR GLASS WEATHERSTRIP
INNER LH
Remove the weatherstrip inner upward in the direction in-
dicated by the arrow mark in the illustration.
REMOVE FRONT DOOR INSIDE HANDLE SUB–ASSY
LH
Using a screwdriver, disengage the claw A indicated.
Move the inside handle in the direction indicated the by
arrow mark in the illustration.
Disconnect the 2 cables from the inside handle.
75–9