Table of Contents
Advertisement
73–20
THEFT DETERRENT & DOOR LOCK
HINT:
Y
When the temperature of the battery is low, the inspection can not be made correctly.
When the outcome of the test is less than 2.2 V, conduct the test again after leaving the battery in a
place with a temperature of 18-C (64_F) for more than 30 minutes.
Y
The automatic power–off function causes the voltage of the battery to be 2.5 V or more (a voltage with
no resistance applied to the battery) when 0.8 seconds have passed after the switch is pressed. There-
fore, make sure to read the voltage just after the switch is pressed.
Y
Because high voltage might be shown once or twice after the battery returns to the specified tempera-
ture, the inspection should be made with the voltage shown after the switch is pressed at least 3 times.
(6)
Disconnect the lead.
(7)
Set the battery (lithium battery) in the transmitter.
AVENSIS REPAIR MANUAL (RM1018E)
–
TRANSMITTER SUB–ASSY MODULE SET DOOR
CONTROL
(2)
Connect the lead to the negative (–) terminal of the
transmitter and install the battery.
Lead
I34797
(3)
Connect the tester positive (+) probe to the (+) bat-
tery (lithium battery) and the tester negative (–)
probe to the lead respectively.
(4)
Press one of the transmission switches on the
transmitter for approx. 1 second.
(5)
Press the transmission switch on the transmitter
again to check the voltage.
Standard: 2.2 V or higher
I34798
http://vnx.su
Advertisement
Table of Contents
