Toyota Avensis ZZT251 2003 Service And Repair Manual page 1776

75–14
Rod
Adhesive
Adhesive
Hole Plug
CE-)(F
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE HOOD/DOOR – FRONT DOOR
(c) Insert the control rod into the door lock, and then set it to
the door panel.
NOTICE:
Make sure that the handle link is securely engaged with the
lock.
B65961
(d) Apply adhesive to the threads of the 3 screws.
Adhesive:
Part No. 08833–00070, THREE BOND 1324 or equiva-
lent
(e) Using a torx socket wrench (T30), install the door lock with
the 3 screws.
Torque: 5.0 N m (51 kgf cm, 44 in. lbf)
(f) Connect the door lock connector.
B66894
27. INSTALL FRONT DOOR OUTSIDE HANDLE COVER
(a) Using a torx socket wrench (T30), install the cover with the
door lock key cylinder installed with the screw.
Torque: 7.0 N m (71 kgf cm, 62 in. lbf)
(b) Install the hole plug.
B68932
28. INSTALL FRONT DOOR FRAME SUB–ASSY REAR
LOWER LH
(a) Install the frame with the bolt.
Torque: 5.5 N m (56 kgf cm, 49 in. lbf)
B62425
29. INSTALL FRONT DOOR WINDOW REGULATOR
SUB–ASSY LH
(a) Apply MP grease to the sliding and rotating areas of the
window regulator.
NOTICE:
Do not apply grease to the spring of the window regulator.
B66972
http://vnx.su