Front Door Adjustment - Toyota Avensis ZZT251 2003 Service And Repair Manual

75–6
ADJUSTMENT
HINT:
Y
Use the same procedures on the RH side as on the LH side.
Centering Bolt
1. INSPECT FRONT DOOR PANEL SUB–ASSY LH
(a) Check that the clearance is within the standard range.
Standard range:
4.6 x 1.5 mm (0.181 x 0.059 in.)
A
5.5 x 1.5 mm (0.220 x 0.059 in.)
B
4.6 x 1.5 mm (0.181 x 0.059 in.)
C
D 160 mm (6.30 in.)
4.8 x 1.5 mm (0.189 x 0.059 in.)
E
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE HOOD/DOOR
Y
Standard Bolt
B57104
A
2.
(a)
(b)
B66966
http://vnx.su
– FRONT DOOR
Because a centering bolt is used as a door hinge mount-
ing bolt on the body side and the door side, the door can
not be adjusted with them on. Substitute a bolt with a
washer for the centering bolt.
B
C
E
ADJUST FRONT DOOR PANEL SUB–ASSY LH
Using SST, adjust the door horizontally and vertically by
loosening the body side hinge bolts.
SST 09812–00010, 09812–00020
Tighten the body side hinge bolts after the adjustment.
SST 09812–00010, 09812–00020
Torque: 26 N m (265 kgf cm, 19 ft lbf)
750MW–01
D
B66965