Editing Idas Data Channels - Teledyne 100E Instruction Manual

Operating Instructions

6.10.2.2. Editing iDAS Data Channels

IDAS configuration is most conveniently done through the APICOM remote control
program. The following list of key strokes shows how to edit using the front panel.
EXIT will return to the
previous SAMPLE
display.
Moves the
display up &
down the list of
Data Channels
Inserts a new Data
Channel into the list
BEFORE the Channel
currently being displayed
Moves the display
between the
PROPERTIES for this
data channel.
Allows to edit the channel name, see next key sequence.
When editing the data channels, the top line of the display indicates some of the
configuration parameters. For example, the display line:
translates to the following configuration:
Channel No.: 0
NAME: CONC
TRIGGER EVENT: ATIMER
PARAMETERS: Four parameters are included in this channel
EVENT: This channel is set up to record 800 data points.
108
SAMPLE* RANGE = 500.000 PPB
< TST TST > CAL
PRIMARY SETUP MENU
SETUP X.X
CFG RNGE PASS CLK MORE
DAS
SETUP X.X DATA ACQUISITION
VIEW
EDIT
SETUP X.X
ENTER DAS PASS: 818
8 1 8
Edit Data Channel Menu
SETUP X.X
0) CONC: ATIMER,
PREV NEXT INS DEL EDIT
Deletes The Data
Channel currently
being displayed
SETUP X.X
NAME:CONC
<SET SET> EDIT PRNT
0) CONC : ATIMER, 4, 800
Model 100E Instruction Manual
SO2 =X.XXX
SETUP
EXIT
EXIT
EXIT
ENTR
2, 900
Exits to the Main
Data Acquisition
PRNT EXIT
Exports the
configuration of all
data channels to
RS-232 interface.
Exits returns to the
previous Menu
EXIT
Reports the configuration of current
data channels to the RS-232 ports.
045150102 Rev XB1
Menu