Figure 56: Installing The Router In The Rack - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
178
Lift the chassis approximately 0.75 in. above the surface of the mounting shelf and
4.
position it as close as possible to the shelf.
Carefully slide the router onto the mounting shelf so that the bottom of the chassis
5.
and the mounting shelf overlap by approximately two inches.
Slide the router onto the mounting shelf until the mounting brackets contact the rack
6.
rails. The shelf ensures that the holes in the mounting brackets of the chassis align
with the holes in the rack rails.
Move the lift away from the rack.
7.
Install a mounting screw into each of the open mounting holes aligned with the rack,
8.
starting from the bottom.
Visually inspect the alignment of the router. If the router is installed properly in the
9.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side and the router should be level.

Figure 56: Installing the Router in the Rack

NOTE: This illustration depicts the router being installed in an open-frame
rack. For an illustration of the mounting hardware required for a four-post
open rack or open cabinet, see Figure 49 on page 168.
Copyright © 2017, Juniper Networks, Inc.