Figure 67: Installing The Router In The Rack - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation
Reinstalling Components in the MX240 Router After Installing it without a Lift
190

Figure 67: Installing the Router in the Rack

NOTE: This illustration depicts the router being installed in an open-frame
rack. For an illustration of the mounting hardware required for a four-post
rack or cabinet, see
MX240 Site Preparation Checklist on page 111
Tools Required to Install the MX240 Router without a Mechanical Lift on page 183
Removing Components from the MX240 Router Before Installing it without a Lift on
page 183
Reinstalling Components in the MX240 Router After Installing it without a Lift on
page 190
After the router is installed in the rack, you reinstall the removed components before
booting and configuring the router. The following procedures describe how to reinstall
components in the chassis, first in the rear and then in the front:
Reinstalling the Power Supplies After Installing the MX240 Router without a
1.
Lift on page 191
Reinstalling the Fan Tray After Installing the MX240 Router without a Lift on page 191
2.
Reinstalling the SCBs After Installing the MX240 Router without a Lift on page 192
3.
Figure 49 on page 168.
Copyright © 2017, Juniper Networks, Inc.