Juniper MX240 Hardware Manual page 352

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation
322
Insert the other end of the cable into the destination port.
4.
Repeat the previous steps for any additional cables.
5.
If the component is offline (its failure indicator LED is lit), use one of the following
6.
methods to bring the PIC online:
To bring a DPC or an MPC online:
Press and hold the corresponding online button on the craft interface until the
green LED next to the button lights steadily, in about 5 seconds.
OK
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
To bring a PIC online:
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in FPC3, use a narrow-ended tool that fits inside the opening that leads to the
button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
To bring a MIC online:
Press the MIC offline/online button until the PIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the
or correct MIC or PIC functioning by issuing the
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
Maintaining MX240 PICs on page 395
Troubleshooting the MX240 PICs on page 410
MX240 PIC Serial Number Label on page 427
MX240 PIC Description on page 59
Replacing an MX240 FPC on page 302
.
CLI Explorer
CLI Explorer .
CLI Explorer .
show chassis fpc
show chassis fpc pic-status
Copyright © 2017, Juniper Networks, Inc.
command
.