Reinstalling Components In The Mx240 Router After Installing It With A Lift; Lift - Juniper MX240 Hardware Manual

Related
Documentation

Reinstalling Components in the MX240 Router After Installing it with a Lift

Reinstalling the Power Supplies After Installing the MX240 Router with a Lift
Copyright © 2017, Juniper Networks, Inc.
MX240 Site Preparation Checklist on page 111
Tools Required to Install the MX240 Router with a Mechanical Lift on page 172
Removing Components from the MX240 Router Before Installing it with a Lift on page 172
Reinstalling Components in the MX240 Router After Installing it with a Lift on page 179
After the router is installed in the rack, you reinstall the removed components before
booting and configuring the router. The following procedures describe how to reinstall
components in the chassis, first in the rear and then in the front:
Reinstalling the Power Supplies After Installing the MX240 Router with a Lift on page 179
1.
2. Reinstalling the Fan Tray After Installing the MX240 Router with a Lift on page 180
Reinstalling the SCBs After Installing the MX240 Router with a Lift on page 181
3.
Reinstalling the DPCs After Installing the MX240 Router with a Lift on page 181
4.
Reinstalling the FPCs After Installing the MX240 Router with a Lift on page 182
5.
Reinstall the rightmost power supply first and then work your way to the left. To reinstall
the AC or DC power supplies (see
the DC power supplies):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
For an AC-powered router, switch the AC input switch on the power supply to the
2.
off ( ) position. For a DC-powered router, switch the circuit breaker on the power
O
supply to the off ( O ) position.
We recommend this even though the power supplies are not connected to power
sources.
Using both hands, slide the power supply straight into the chassis until the power
3.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Tighten the captive screws.
4.
Chapter 16: Installing the MX240 Router
Figure 57 on page 180, which shows the installation of
179