Cooling System Components And Descriptions; Mx240 Cooling System Description; Figure 8: Airflow Through The Chassis - Juniper MX240 Hardware Manual
3d universal edge router
Hide thumbs
Also See for MX240:
- Hardware manual (510 pages) ,
- Instruction for upgrading (35 pages) ,
- Quick start manual (31 pages)
Table of Contents
Advertisement
CHAPTER 4
Cooling System Components and
Descriptions
MX240 Cooling System Description
Copyright © 2017, Juniper Networks, Inc.
MX240 Cooling System Description on page 17
MX240 Fan LED on page 18
The cooling system consists of the following components:
Fan tray
Air filter
The cooling system components work together to keep all router components within the
acceptable temperature range (see
Figure 10 on page
18). The router has one fan tray and one air filter that install vertically
in the rear of the router. The fan tray contains three fans. The MX Series high-capacity
fan trays satisfy cooling requirements for high-density DPCs and MPCs, and must be
upgraded for proper cooling.
The air intake to cool the chassis is located on the side of the chassis next to the air filter.
Air is pulled through the chassis toward the fan tray, where it is exhausted out the side
of the system. The air intake to cool the power supplies is located in the front of the router
above the craft interface. The exhaust for the power supplies is located on the rear
bulkhead power supplies.
Figure 8: Airflow Through the Chassis
The host subsystem monitors the temperature of the router components. When the
router is operating normally, the fans function at lower than full speed. If a fan fails or
Figure 8 on page
17,
Figure 9 on page
18, and
17
Advertisement
Table of Contents
Troubleshooting
