Upgrading an MX240 SCB
Copyright © 2017, Juniper Networks, Inc.
Figure 158: Installing an SCB
Preparing for the Upgrade on page 359
1.
Upgrading the SCB in the Backup Routing Engine on page 361
2.
3.
Upgrading the SCB in the Master Routing Engine on page 363
Completing the SCB Upgrade on page 365
4.
Preparing for the Upgrade
NOTE:
Do not make other changes to the CLI during the entire upgrade
process. You can ensure that you will not make such changes by opening a
telnet session to the master RE CLI operational mode and issuing the
command. This command locks the configuration procedure.
exclusive
TIP:
To prevent traffic loss during the upgrade process, we recommend that
you operate the line cards at 50% line rate. This 50% limit must be
maintained per PFE on each line card.
Chapter 27: Replacing Switch Fabric Components
configure
359