Juniper MX240 Hardware Manual page 435

Copyright © 2017, Juniper Networks, Inc.
Check the LED on the DPC and
OK/FAIL
When the DPC is online and functioning normally, the
Issue the show chassis fpc
in the sample output, the value
DPC is functioning normally:
user@host> show chassis fpc
Temp CPU Utilization (%)
Slot State (C)
0 Online 41
1 Online 43
2 Online 43
3 Empty
4 Empty
5 Online 42
NOTE: The show chassis fpc
For more detailed output, add the
a slot number, which is optional:
user@host> show chassis fpc detail
Slot 2 information:
State
Temperature
Total CPU DRAM
Total SRAM
Total SDRAM
Start time
Uptime
Slot 4 information:
State
Temperature
Total CPU DRAM
Total SRAM
Total SDRAM
Start time
Uptime
Slot 7 information:
State
Temperature
Total CPU DRAM
Total SRAM
Total SDRAM
Start time
Uptime
For further description of the output from the commands, see the Junos OS
Administration Library.
Chapter 30: Troubleshooting Components
and
OK FAIL
command to check the status of installed DPCs. As shown
in the column labeled
Online
Memory
Total Interrupt
9 0
5 0
11 0
6 0
command displays the status of the DPCs.
detail option. The following example does not specify
Online
22 degrees C / 71 degrees F
1024 MB
256 MB
0 MB
2006-11-03 07:35:40 PST
2 hours, 27 minutes, 1 second
Online
22 degrees C / 71 degrees F
1024 MB
256 MB
0 MB
2006-11-03 07:35:48 PST
2 hours, 26 minutes, 53 seconds
Online
24 degrees C / 75 degrees F
1024 MB
256 MB
0 MB
2006-11-03 07:35:53 PST
2 hours, 26 minutes, 48 seconds
DPC LEDs on the craft interface.
LED lights green steadily.
OK
indicates that the
State
Utilization (%)
DRAM (MB) Heap Buffer
1024 15
1024 16
1024 16
1024 16
57
57
57
57
405