Power Supply LEDs on the MX240 Craft Interface
DPC and MPC LEDs on the MX240 Craft Interface
FPC LEDs on the MX240 Craft Interface
Copyright © 2017, Juniper Networks, Inc.
Table 7: Host Subsystem LEDs on the Craft Interface (continued)
Label
Color
Red
OFFLINE
–
Each power supply has two LEDs on the craft interface that indicate its status. The LEDs,
labeled
through
, are located on the upper left of the craft interface next to the
0
3
label.
Table 8 on page 15
describes the functions of the power supply LEDs on the craft
interface.
Table 8: Power Supply LEDs on the Craft Interface
Label
Color
Green
PEM
Red
Each DPC or MPC has LEDs on the craft interface that indicate its status. The LEDs,
labeled
,
, and
, (
shows status of either SCB1, DPC0, MPC0, or FPC0 depending
1/0
1
2
1/0
on which component is installed in the slot), are located along the bottom of the craft
interface. See
Table 9 on page
Table 9: DPC and MPC LEDs on the Craft Interface
Label
Color
Green
OK
–
Red
FAIL
An FPC takes up two DPC slots when installed in an MX Series router. An FPC LED located
along the bottom of the craft interface indicates status. The LED corresponds to the
lowest DPC slot number in which the FPC is installed. See
Chapter 3: Chassis Components and Descriptions
State
Description
On steadily
Host is installed but the Routing Engine is offline.
Off
Host is not installed.
State
Description
On steadily
Power supply is functioning normally.
On steadily
Power supply has failed or power input has failed.
15.
State
Description
On steadily
Card is functioning normally.
Blinking
Card is transitioning online or offline.
Off
The slot is not online.
On steadily
Card has failed.
PEM
Table 10 on page
16.
15