Installing An Mx240 Dpc; Figure 91: Installing A Routing Engine - Juniper MX240 Hardware Manual

Related
Documentation

Installing an MX240 DPC

Copyright © 2017, Juniper Networks, Inc.
Press both of the ejector handles inward to seat the Routing Engine.
6.
Tighten the captive screws on the left and right of the Routing Engine.
7.
Connect the management device cables to the Routing Engine.
8.
The Routing Engine might require several minutes to boot.
After the Routing Engine boots, verify that it is installed correctly by checking the
, and LEDs on the craft interface. If the router is operational and the Routing
RE0 RE1
Engine is functioning properly, the green
lights steadily instead, remove and install the Routing Engine again. If the red
still lights steadily, the Routing Engine is not functioning properly. Contact your customer
support representative.
To check the status of the Routing Engine, use the CLI command:
user@host> show chassis routing-engine
Routing Engine status:
For more information about using the CLI, see the Junos OS documentation.

Figure 91: Installing a Routing Engine

Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
Replacing Connections to MX240 Routing Engine Interface Ports on page 285
Removing an MX240 Routing Engine on page 275
MX240 Routing Engine Description on page 23
A DPC weighs up to 14.5 lb (6.6 kg). Be prepared to accept its full weight.
LED lights steadily. If the red
ONLINE
Slot 0: Current state
Chapter 21: Installing Components
FAIL ,
LED
FAIL
FAIL LED
Master ...
233