MX240 3D Universal Edge Router Hardware Guide
Related
Documentation
Powering On an AC-Powered MX240 Router
200
Figure 73: Connecting AC Power to the Routers
Connecting an MX240 AC Power Supply Cord on page 206
Disconnecting an MX240 AC Power Supply Cord on page 338
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
AC Power Cord Specifications for the MX240 Router on page 140
To power on an AC-powered router:
Verify that the power supplies are fully inserted in the chassis.
1.
Verify that each AC power cord is securely inserted into its appliance inlet.
2.
Verify that an external management device is connected to one of the Routing Engine
3.
ports (
,
, or
AUX
CONSOLE
Turn on the power to the external management device.
4.
Switch on the dedicated customer site circuit breakers for the power supplies. Follow
5.
the instructions for your site.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
6.
ESD points on the chassis.
Switch the AC input switch on each power supply to the on (
7.
the status LEDs on each power supply faceplate. If an AC power supply is correctly
).
ETHERNET
|
) position and observe
Copyright © 2017, Juniper Networks, Inc.