Figure 142: Removing A Pic - Juniper MX240 Hardware Manual

3d universal edge router

Hide thumbs Also See for MX240:

Table of Contents

Arrange the cable to prevent it from dislodging or developing stress points. Secure

the cable so that it is not supporting its own weight as it hangs to the floor. Place

excess cable out of the way in a neatly coiled loop.

Avoid bending fiber-optic cable beyond its minimum bend

radius. An arc smaller than a few inches in diameter can damage the cable

and cause problems that are difficult to diagnose.

For an FPC3 PIC, loosen the captive screw at the bottom of the PIC faceplate, then

twist the ejector handle at the top of the faceplate counterclockwise to unseat the

Slide the PIC out of the FPC card carrier and place it in the electrostatic bag or on the

antistatic mat.

If you are not reinstalling a PIC into the emptied PIC slot within a short time, install a

blank PIC panel over the slot to maintain proper airflow in the FPC card cage.

Figure 142: Removing a PIC

Chapter 25: Replacing Line Card Components