Installing The Mx240 Chassis In The Rack Manually - Juniper MX240 Hardware Manual

Installing the MX240 Chassis in the Rack Manually

Copyright © 2017, Juniper Networks, Inc.
To install the router in the rack (see
CAUTION: If you are installing more than one router in a rack, install the
lowest one first. Installing a router in an upper position in a rack or cabinet
requires a lift.
CAUTION: Before front mounting the router in a rack, have a qualified
technician verify that the rack is strong enough to support the router's weight
and is adequately supported at the installation site.
CAUTION: Lifting the chassis and mounting it in a rack requires two people.
The empty chassis weighs approximately 52.0 lb (23.6 kg).
Ensure that the rack is in its permanent location and is secured to the building. Ensure
1.
that the installation site allows adequate clearance for both airflow and maintenance.
Position the router in front of the rack or cabinet, centering it in front of the mounting
2.
shelf. Use a pallet jack if one is available.
With one person on each side, hold onto the bottom of the chassis and carefully lift
3.
it onto the mounting shelf.
WARNING: To prevent injury, keep your back straight and lift with your
legs, not your back. Avoid twisting your body as you lift. Balance the load
evenly and be sure that your footing is solid.
Slide the router onto the mounting shelf until the mounting brackets contact the rack
4.
rails. The shelf ensures that the holes in the mounting brackets of the chassis align
with the holes in the rack rails.
Install a mounting screw into each of the open mounting holes aligned with the rack,
5.
starting from the bottom.
Visually inspect the alignment of the router. If the router is installed properly in the
6.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side and the router should be level.
Chapter 16: Installing the MX240 Router
Figure 67 on page 190):
189