Installing An Mx240 Ac Normal-Capacity Power Supply - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation

Installing an MX240 AC Normal-Capacity Power Supply

256
Carefully align the transceiver with the slots in the component. The connectors should
4.
face the component.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
7.
the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Verify that the status LEDs on the component faceplate indicate that the SFP or XFP
8.
is functioning correctly. For more information about the component LEDs, see the
Series Interface Module Reference
MX240 Dense Port Concentrator (DPC) Description on page 49
MX240 PIC Description on page 59
MX240 Modular Port Concentrator (MPC) Description on page 77
MX240 Modular Interface Card (MIC) Description on page 70
Replacing a Cable on an MX240 DPC, MPC, MIC, or PIC on page 320
Removing an SFP or XFP Transceiver from an MX240 DPC, MPC, MIC, or PIC on page 323
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
To install an AC power supply (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Move the AC input switch next to the appliance inlet on the power supply to the off (
2.
position.
Using both hands, slide the power supply straight into the chassis until the power
3.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
.
Figure 104 on page 257):
Copyright © 2017, Juniper Networks, Inc.
MX
)
O