Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
You hold an FPC horizontally when installing it into the chassis or an equipment rack. To
hold an FPC vertically (see
Orient the FPC so that the faceplate faces you.
1.
Place one hand around the FPC faceplate about a quarter of the way down from the
2.
top edge. To avoid deforming the electromagnetic interference (EMI) shielding strip,
do not press hard on it.
Place your other hand at the bottom edge of the FPC. If the FPC has heat sinks about
3.
midway between the faceplate and connector edge, place your other hand against
the heat sinks.
Figure 164: Holding an FPC Vertically
MX240 FPC Terminology
Storing an MX240 FPC on page 392
Replacing an MX240 FPC on page 302
Tools and Parts Required to Replace MX240 Hardware Components on page 226
Figure 164 on page
391):
Chapter 29: Maintaining Components
391