Installing An Mx240 Mic - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation

Installing an MX240 MIC

240
MX240 Flexible PIC Concentrator (FPC) Description on page 57
Maintaining MX240 FPCs on page 387
Removing an MX240 FPC on page 302
Installing an MX240 PIC on page 247
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
MX240 DPC Serial Number Label on page 422
To install a MIC (see Figure 96 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If you have used a dual-wide MIC and are now replacing it with two "single" MICs,
2.
install the septum (see
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in "Removing an MX240 MPC" on page
Position the septum in the center of the MPC so that it lines up with holes labeled
b.
on the top of the MPC.
S
Insert a screw into each of the two holes labeled
c.
On the bottom of the MPC, insert a screw into each of the four holes labeled
d.
then tighten completely.
Install the MPC as described in
e.
242):
Figure 95 on page 241):
"Installing an MX240 MPC" on page
311).
, and then tighten completely.
S
243.
Copyright © 2017, Juniper Networks, Inc.
, and
S