Replacing An Mx240 Mpc; Removing An Mx240 Mpc; Figure 139: Installing A Mic - Juniper MX240 Hardware Manual

Related
Documentation

Replacing an MX240 MPC

Removing an MX240 MPC

Copyright © 2017, Juniper Networks, Inc.
Press the MIC offline/online button until the MIC
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot mic-slot mic-slot online
For more information about the command, see the
The normal functioning status LED confirms that the MIC is online. You can also verify
correct MIC functioning by issuing the
in "Maintaining MX240 MICs" on page

Figure 139: Installing a MIC

MX240 Modular Interface Card (MIC) Description on page 70
Maintaining MX240 MICs on page 393
Troubleshooting the MX240 MICs on page 408
MX240 MIC Serial Number Label on page 424
Removing an MX240 MPC on page 311
1.
Installing an MX240 MPC on page 313
2.
When you remove an MPC, the router continues to function, although the MIC interfaces
installed on the MPC being removed no longer function.
An MPC installs horizontally in the front of the router. The MPCs are hot-insertable and
hot-removable. A fully configured MPC can weigh up to 18.35 lb (8.3 kg). Be prepared to
accept its full weight.
To remove an MPC (see Figure 140 on page
Have ready a replacement MPC or DPC blank panel and an antistatic mat for the MPC.
1.
Also have ready rubber safety caps for each MIC using an optical interface on the MPC
that you are removing.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Chapter 25: Replacing Line Card Components
LED lights green.
OK/FAIL
CLI Explorer
show chassis fpc pic-status
393.
313):
.
command described
311