Powering Off The Mx240 Router; Connecting An Mx240 Ac Power Supply Cord - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide

Powering Off the MX240 Router

Related
Documentation

Connecting an MX240 AC Power Supply Cord

206
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
DC Power Cable Specifications for the MX240 Router on page 160
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
To power off the router:
On the external management device connected to the Routing Engine, issue the
1.
request system halt both-routing-engines
shuts down the Routing Engines cleanly, so their state information is preserved. (If
the router contains only one Routing Engine, issue the
user@host> request system halt both-routing-engines
Wait until a message appears on the console confirming that the operating system
2.
has halted. For more information about the command, see the
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
3.
ESD points on the chassis.
Move the AC input switch on the chassis above the AC power supply or the DC circuit
4.
breaker on each DC power supply faceplate to the off (
Powering On an AC-Powered MX240 Router on page 200
Powering On a DC-Powered MX240 Router with Normal Capacity Power Supplies on
page 204
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
To connect the AC power cord:
Locate a replacement power cord with the type of plug appropriate for your
1.
geographical location (see
page 140).
Connect the power cord to the power supply.
2.
Insert the power cord plug into an external AC power source receptacle.
3.
operational mode command. The command
"AC Power Cord Specifications for the MX240 Router" on
Copyright © 2017, Juniper Networks, Inc.
request system halt command.)
CLI Explorer .
O ) position.