Port Vdsl Pvid Command - ZyXEL Communications MSC1000G User Manual

25.15.5 port vdsl pvid Command

Syntax:
port vdsl pvid <slot-port> <vid>
This command sets the port VID on the VDSL port(s).
25.15.6 port vdsl rfiband Command
Syntax:
port vdsl rfiband <slot-port> <disable|ansi|etsi|custom>
where
<disable|ansi|etsi
|custom>
Use this command to specify an RFI mode or disable this feature.
25.15.7 port vdsl rficustom Commands
Syntax:
port vdsl rficustom disable <index>
port vdsl rficustom enable <index>
port vdsl rficustom set <index> <start_freq> <stop_freq>
port vdsl rficustom show
where
<index>
<start_freq>
<stop_freq>
Use these commands to configure or display the settings of a custom RFI entry.
An example is show below:
• Creates a custome RFI entry with the frequency between 3500 and 3800 kHz.
Chapter 25 port Commands
= Enter or
ansi etsi
Enter to deactivate this feature.
disable
Enter to use the RFI band settings configured using the
custom
port vdsl rficustom
= This is index number (1-8) of the custom RFI entry.
= This is the start of the freqiency range in kHz ( 0~2147483647).
Note:
<start_freq>
= This is the end of the frequency range in kHz.
MSC1000G User's Guide
to use the pre-defined RFI band.
command.
cannot be bigger than .
<stop_freq>
391