Chapter 25 Port Commands; Port Commands Summary - ZyXEL Communications MSC1000G User Manual

This chapter shows you how to use the
25.1 Commands Summary
port
The following table lists the
administrator privilege level needed to use the command (H for high, M for middle or L for
low).
Table 141 port Commands
COMMAND
port
adsl
alarmprof
annexl
annexm
annexi
dscarrier0
dscarrier1
inpmin

Chapter 25 port Commands

C
H A P T E R
port Commands
commands.
port
commands.The P column on the right indicates the
port
<slot-port>
<alarmprofile>
disable <slot-port> Turns off the Annex L reach extended
enable <slot-port>
[narrow]
disable <slot-port> Turns off the Annex M double upstream
enable <slot-port>
disable <slot-port> Turns off the Annex I all digital mode
enable <slot-port>
<slot-port> <m1>
<m2> <m3> <m4> <m5>
<m6> <m7>
<slot-port> <m1>
<m2> <m3> <m4> <m5>
<m6> <m7>
<slot-port>
<us_inp> <ds_inp>
MSC1000G User's Guide
DESCRIPTION
ADSL port specific commands
Applies an ADSL alarm profile to the
subscriber port.
feature.
Turns on the Annex L reach extended
feature. If the 'narrow' is not entered then
Annex L mode will be enabled as 'wide'
PSD mode.
feature.
Turns on the Annex M double upstream
feature (upstream tones from 6 to 63).
feature.
Turns on the Annex I all digital mode
feature.
Disables downstream carrier tones from 33
to 255.
<m1>~<m7> = carrier tones, 0~ffffffff,
'1' disables the corresponding tone.
Disables downstream carrier tones from
256 to 511.
<m1>~<m7>
= carrier tones, 0~ffffffff,
'1' disables the corresponding tone.
Sets the upstream (us) and downstream
(ds) Impulse Noise Protection minimum
setting (0~6).
2 5
P
M
M
M
M
M
M
M
M
M
M
359