Port Adsl Dscarrier1 Command; Port Adsl Inpmin Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide

25.3.9 port adsl dscarrier1 Command

Syntax:
port adsl dscarrier1 <slot-port> <m0> <m1> <m2> <m3> <m4> <m5> <m6> <m7>
where
~
<m0> <m7>
This command disables downstream carrier tones from 256 to 511 on the specified ADSL2+
port(s). Use this command to have the system not use an ADSL line's tones that are known to
have a high noise level.
The following example disables downstream carrier tone 301 for ADSL2+ port 5 on the line
card in slot 7.
ras> port adsl dscarrier1 7-5 0 00001000 0 0 0 0 0 0
The following example disables downstream carrier tones 301 to 304 for ADSL2+ port 5 on
the line card in slot 7.
ras> port adsl dscarrier1 7-5 0 0000f000 0 0 0 0 0 0

25.3.10 port adsl inpmin Command

Syntax:
port adsl inpmin <slot-port> <us_inp> <ds_inp>
368
= The downstream carrier tones to be disabled. Each <mx> can
use up to 8 hexadecimal digits (0~ffffffff). Each <mx>
represents 32 carrier tones (each hexadecimal digit represents 4
tones).
= tones 256~287
<m0>
= tones 288~319
<m1>
= tones 320~351
<m2>
= tones 352~383
<m3>
= tones 384~415
<m4>
= tones 416~447
<m5>
= tones 448~479
<m6>
= tones 480~511
<m7>
The hexadecimal digit is converted to binary and a '1' disables
the corresponding tone. Disabling a carrier tone turns it off so
the system does not send data on it.
Chapter 25 port Commands