Acl Maccount Commands - ZyXEL Communications MSC1000G User Manual

17.5 acl maccount Commands

Use
maccount
statically configured on a DSL port. MAC count commands are listed next.
Note: You cannot enable both MAC count and MAC filtering on the same port at the
same time.
17.5.1 acl maccount disable Command
Syntax:
acl maccount disable <slot-port>
This command disables the MAC count limit on the specified DSL port(s).
The following example turns off the MAC count limit on DSL port 4 on a line card in slot 5.
ras> acl maccount disable 5-4
17.5.2 acl maccount enable Command
Syntax:
acl maccount enable <slot-port>
This command enables the MAC count limit on the specified DSL port(s). You can only
enable the MAC count filter on DSL ports that do not have the MAC filter enabled.
The following example turns on the MAC count limit on DSL port 4 on a line card in slot 5.
ras> acl maccount enable 5-4
17.5.3 acl maccount set Command
Syntax:
acl maccount set <slot-port> <count>
Chapter 17 acl Commands
commands to limit how many MAC addresses may be dynamically learned or
MSC1000G User's Guide
305