Switch Commands; Table 127 Switch Commands - ZyXEL Communications MSC1000G User Manual

Table 126 show Commands (continued)
COMMAND
performance
sys
rmon
user
vlan

16.7.12 switch Commands

The
switch

Table 127 switch Commands

COMMAND
switch
bandwidth
bcastctrl
dot3ad
Chapter 16 Commands
<slot-port>
curr|15min|1day
stats|history
sub1|sub2|up1|up2
[<vid>]|[
<start-vid> <end-
vid>]
commands configure switching functions and manage the Ethernet interfaces.
disable <giga-port>
enable <giga-port>
set <giga-port>
<ingress-rate>
<egress-rate>
show
show
threshold <giga-port> <bc-
limit> <mc-limit>
<uu-limit>
disable sub|up
enable sub|up [lacp]
priority <priority> Sets the LACP system priority (0~65535).
lacp
show
timeout short|long
MSC1000G User's Guide
DESCRIPTION
Displays a DSL port's performance
counters.
Displays the CPU utilization and
memory usage status.
Displays subtending/uplink link RMON
information.
Displays information on logged in
users. * denotes your session.
Displays current VLANs.
DESCRIPTION
Turns off bandwidth control on the specified
port(s).
Turns on bandwidth control on the specified
port(s).
Sets the incoming or outgoing bandwidth
control for the specified port(s). 0~1000
(Mbps).
Displays the bandwidth control settings.
Displays broadcast and multicast storm
control settings.
Sets the limitations of broadcast, multicast
and unknown unicast packets, in packets
per second for each trunk port (0~262143, -
1 means no limit).
<bc-limit>
= broadcast packet limit
<mc-limit> = multicast packet limit
<uu-limit>
= unknown unicast packet
limit
Turns off link aggregation on subtending or
uplink ports.
Turns on link aggregation on subtending or
uplink ports. lacp turns on LACP protocol.
Displays LACP settings.
Sets the time interval between exchanging
LACP packets.
P
L
L
L
L
L
P
M
M
M
L
L
M
M
M
M
L
M
283