Profile Shdsl Commands - ZyXEL Communications MSC1000G User Manual

26.11 profile shdsl Commands

Use the
profile shdsl
26.11.1 profile shdsl set Command
Syntax:
profile shdsl set <profile> <min-rate> <max-rate>
[annexa|annexb 2wire|4wire|mpair4
[lp_off | lp_on_cur [curr_margin] | lp_on_wc [worst_margin]]]
where
<profile>
<min-rate>
<max-rate>
annexa|annexb
2wire|4wire|mpair
4
lp_off
lp_on_cur
lp_on_wc
Chapter 26 profile Commands
commands to configure SHDSL profiles.
= The descriptive name for the profile.
= The minimum transmission rate in Kbps. (192~4096)
= The maximum transmission rate in Kbps. (192~4096)
= The region setting, annexb is the default.
= DSL over POTS.
annexa
= DSL over ISDN.
annexb
= The wire pair number.
= a normal connection using a single SHDSL port's two
2wire
wires, this is the default.
= a 4-wire n-wire group (two SHDSL ports grouped
4wire
together).
= an 8-wire n-wire group (four SHDSL ports grouped
mpair4
together).
= Disable line probe.
The SHDSL line card and subscriber modem use line probes to
determine the best possible transmission rate. This is used in
rate adaptation. This is the default line probe mode.
If you disable line probe, the system skips the rate adaptation
phase to shorten connection set up time.
= Enable line probe with current target Signal to Noise Ratio
margin.
= Enable line probe with worst case target Signal to Noise Ratio
margin.
MSC1000G User's Guide
423