ZyXEL Communications MSC1000G User Manual page 287

Table 128 sys Commands (continued)
COMMAND
hostname
location
show
monitor set
show
multilogin disable
enable
show
reboot
[show]
<sec>
[cancel]
server enable
disable
port
show
snmp getcommunity
setcommunity
show
trapcommunity <community>
trapdst
Chapter 16 Commands
<hostname>
<location>
<slot>
<volt|temp|fan|cup
> <index> <high-
limit> <low-limit>
<slot>
telnet|ssh|ftp|web
|icmp|snmp
telnet|ssh|ftp|web
|icmp|snmp
telnet|ftp|web|snm
p|ssh <port>
<community>
<community>
<index>
<destination>
[<port>]
[v1|v2c|v3]
[<name>]
MSC1000G User's Guide
DESCRIPTION
Sets the system name.
Sets the geographic location of the
system.
Displays general system and MSC
information.
Sets the hardware monitor threshold
settings.
Displays the hardware monitor threshold
settings of a slot.
Turns off multiple concurrent logins.
Turns on multiple concurrent logins.
Displays the multiple login setting.
Restarts the system.
Displays the reboot schedule.
Sets the number of seconds
(1~2147483647) before the system
reboots. If there is no time specified, the
system reboots immediately.
Aborts the scheduled system rebooting.
Turns on service access to the switch.
Turns off service access to the switch.
Sets a port for a service.
Displays service access control settings.
Sets the SNMP GetRequest community.
Sets the SNMP SetRequest community.
Displays SNMP settings.
Sets the SNMP Trap community.
Sets the IP addresses and listening ports
for up to four SNMP trap server IP
addresses and listening ports. Set 0.0.0.0
to not send any SNMP traps.
<name> = username to be included in
trap packets. Only applicable for V3.
P
M
M
L
M
L
M
M
L
H
H
H
H
M
M
M
L
M
M
L
M
M
287