Profile Atm Set Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
The following example displays the DEFVAL ATM profile.
ras> profile atm show DEFVAL
atm profile: DEFVAL
traffic class: ubr
pcr
cdvt
ras>

26.8.2 profile atm set Command

Syntax:
profile atm set <atmprofile> cbr|ubr <pcr> <cdvt>
or
profile atm set <atmprofile> rt-vbr|nrt-vbr <pcr> <cdvt> <scr> <bt>
where
<atmprofile>
<ubr|cbr>
<pcr>
[cdvt]
rt-vbr)|nrt-vbr
<scr>
<bt>
This command creates a profile of ATM traffic settings.
After you create an ATM profile, you can use it with the
command to assign it to a virtual circuit.
418
: 300000
: 0
= The name of the ATM profile (up to 31 ASCII characters). You
cannot change the DEFVAL profile.
= The ubr (unspecified bit rate) or cbr (constant bit rate) ATM
traffic class.
= Peak Cell Rate (
second) at which the sender can send cells. * sets the default
value.
= Cell Delay Variation Tolerance is the accepted tolerance of the
difference between a cell's transfer delay and the expected
transfer delay (number of cells). 0 to 255 cells or * for the
default value.
= The Real-Time Variable Bit Rate (vbr) or Non Real-Time
Variable Bit Rate (nrt-vbr) Variable Bit Rate ATM traffic class.
= The Sustainable Cell Rate (150~300000) sets the average cell
rate (long-term) that can be transmitted (cells per second). SCR
applies with the vbr traffic class. * sets the default value.
= Burst Tolerance this is the maximum number of cells (0~255)
that the port is guaranteed to handle without any discards. BT
applies with the vbr traffic class. * sets the default value.
), the maximum rate (cells per
150~300000
port ppvc set
Chapter 26 profile Commands
or
port pvc set