Switch Qschedule Commands - ZyXEL Communications MSC1000G User Manual

ras> switch port vlantrunk disable sub1

28.11 switch qschedule Commands

Use these commands to set a port's queuing method and/or priority weight.
28.11.1 switch qschedule set Command
Syntax:
switch qschedule set <giga-port> spq
or
<giga-port> wrr <wt0> <wt1> <wt2> <wt3> <wt4> <wt5> <wt6> <wt7>
where
<giga-port>
spq
wrr
<wt0> <wt1> <wt2>
<wt3> <wt4> <wt5>
<wt6> <wt7>
This command sets a Gigabit Ethernet interface's queuing method and/or priority weight.
The following example sets the subtending 1Gigabit Ethernet interface to use Strict Priority
Queuing.
ras> switch qschedule set sub1 spq
28.11.2 switch qschedule show Command
Syntax:
switch qschedule show
Chapter 28 switch Commands
= This represents Gigabit Ethernet uplink ports, subtending ports
or all ports. Use
sub1|sub2|up1|up2|all i
enabled. Use
tsub|tup|all
= Strict Priority Queuing (SPQ) services queues based on priority
only. When the highest priority queue empties, traffic on the
next highest-priority queue begins.
= Weighted Round Robin services queues based on their priority
and queue weight. WRR is activated only when a port has more
traffic than it can handle.
= The priority weight for each queue, 0~15.
MSC1000G User's Guide
f trunking is not
if trunking is enabled.
483