Figure 108 Igmp Filter Profile; Table 69 Igmp Filter Profile - ZyXEL Communications MSC1000G User Manual

Ies-5000 series management switch card
Hide thumbs Also See for MSC1000G:
Table of Contents

Advertisement

MSC1000G User's Guide
Click Profile > IGMP Filter in the navigation panel to open the following screen. Use this
screen to configure IGMP filter profiles. Later you can apply the IGMP filter profiles to ADSL
ports in the ADSL Port Setup screens.
The DEFVAL IGMP filter profile is assigned to all ADSL ports by default. It allows a port to
join all multicast IP addresses (224.0.0.0~239.255.255.255). If you want to allow an ADSL
subscriber access to only specific IGMP multicast groups, use the IGMP Filter Profile screen
to configure a different profile and then assign it to the subscriber's ADSL port in the ADSL
Port Setting screens.
Use the top part of the screen to add or edit IGMP filter profiles. The bottom of the screen lists
the configured IGMP filter profiles.

Figure 108 IGMP Filter Profile

The following table describes the fields in this screen.

Table 69 IGMP Filter Profile

LABEL
Name
Start IP
End IP
Apply
New
Cancel
Index
180
DESCRIPTION
Type a name to identify the IGMP filter profile (you cannot change the name of the
DEFVAL profile). You can use up to 31 ASCII characters; spaces are not allowed.
Enter the starting multicast IP address for a range of multicast IP addresses to
which you want this IGMP filter profile to allow access.
Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.If you want to add a single multicast IP
address, enter it in both the Start IP and End IP fields.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh
profile without saving your changes.
Click Cancel to start configuring the screen again.
This is the index number of the IGMP profile.
Chapter 11 Profile Screens

Advertisement

Table of Contents
loading

Table of Contents