Port Paepvc Show Command; Port Ppvc Commands; Port Ppvc Delete Command; Port Ppvc Member Delete Command - ZyXEL Communications MSC1000G User Manual

The following example creates a PPPoA-to-PPPoE PVC (
slot . The PVC uses
3
This configuration is for the
until the
hellowtime
ras> port paepvc set 3-1-1/33 DEFVAL llc 2 1 acname vom srvcname video
hellotime 10

25.8.3 port paepvc show Command

Syntax:
port paepvc show <slot>|<slot-port>|<slot-port-vpi/vci>
This command displays the PPPoA-to-PPPoE PVC settings for the specified port and/or slot.
The following example displays the settings on the line card in slot 3.
ras> port paepvc show 3
pvc
-------------- ------- ----- ------ ---- ----- --------------------------
3-1-1/33
ras>

25.9 port ppvc Commands

Use the
port ppvc

25.9.1 port ppvc delete Command

Syntax:
port ppvc delete <slot-port-vpi/vci>
This command removes a PPVC. Removing a PPVC also deletes all of the member PVCs.
The following example removes a PPVC with VPI 8 and VCI 35 for port 5 on the line card in
slot 7.
ras> port ppvc delete 7-5-8/35

25.9.2 port ppvc member delete Command

Syntax:
port ppvc member delete <slot-port-vpi/vci> <vpi/vci>
Chapter 25 port Commands
encapsulation and the
llc
service on the
video
timeout before terminating the PPPoE session.
type mux pvid pri
pae llc 2
commands to configure PPVCs and add and remove member PVCs.
MSC1000G User's Guide
) for port
1/33
ATM profile with a priority of
DEFVAL
access concentrator. The switch waits
vom
htime profile/acname/srvcname
1 10 DEFVAL/test/example
on the line card in
1
.
1
377