2.3.3.1 Transceiver Installation
Use the following steps to install a mini GBIC transceiver (SFP module) in the MSC1000-
GBA module.
Note: The slot is at an angle. Do not attempt to straighten it.
1 Remove the dust cover from the transceiver.
2 For transceivers with a flip-up or flip-down latch, close the latch.
3 Insert the fiber-optic cables into the transceiver (you may need to remove cable dust
covers).
4 Insert the transceiver into the slot with the exposed section of PCB board facing down.
5 Press the transceiver firmly until it clicks into place.
Figure 5 Transceiver Installation
Figure 6 Installed Transceiver
2.3.3.2 Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module) from the MSC1000-
GBA module.
1 Remove the fiber-optic cables from the transceiver.
2 Unlock the transceiver's latch (latch styles vary).
3 Pull the transceiver out of the slot.
4 Put the transceiver's dust cover on the transceiver.
Chapter 2 Hardware Connections
MSC1000G User's Guide
55