Figure 69 Static Multicast; Table 37 Static Multicast - ZyXEL Communications MSC1000G User Manual

Figure 69 Static Multicast

The following table describes the related labels in this screen.

Table 37 Static Multicast

LABEL
VID
Group IP
Type a VID and a group IP and click Apply to display entries in the first table.
Index
Cardname
Port
Apply
New
Cancel
Modify
Delete
VID
Group IP
Chapter 9 IGMP Screens
DESCRIPTION
Type the number of the VLAN that this static multicast group is to use.
This is the static multicast IP address.
This column lists the slot numbers of the line cards. Click the number of an active line
card to go to a screen where you can set the membership of each of the card's ports
for this static multicast group.
This field displays the type of card installed in a slot.
This section lists the VLAN membership setting of each port on each line card. An "F"
indicates that the port is a permanent member of the static multicast group. An "X"
indicates that the port is forbidden (blocked) from joining the static multicast group. An
"-" indicates that the port is a normal member and can join the group dynamically.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
After you click Apply, entries display in the first table so you can edit them. Click New
if you want to configure a different static multicast group.
Click Cancel to begin configuring the screen again.
Select a static multicast group's radio button and click Modify to display the static
multicast group in the table above so you can edit it.
Select a static multicast group's radio button and click Delete to remove the static
multicast group.
This is the number of the VLAN that this static multicast group uses.
This is the static multicast IP address.
MSC1000G User's Guide
121