ZyXEL Communications MSC1000G User Manual page 280

MSC1000G User's Guide
Table 125 profile Commands (continued)
COMMAND
profsvr
shdsl
280
map <igmpfilter>
set <igmpfilter>
<index> <startip>
<endip>
show [igmpprofile]
show
mode client|server
clientlist set <ip> <type>
delete <ip>
show
serverset <ip>
sync
delete <profile>
map <profile>
set <profile> <min-
rate> <max-rate>
[annexa|annexb
2wire|4wire|mpair
4
[lp_off |
lp_on_cur
[curr_margin] |
lp_on_wc
[worst_margin]]]
DESCRIPTION
Displays which ports reference this
IGMP filter profile.
Creates an IGMP filter profile of ATM
traffic settings.
<igmpfilter> = profile name
<index>
= index of address, 1~16
<startip> = start of address range
<endip> = end of address range
Lists the IGMP filter profiles or a
specific profile's settings.
Displays the current profile server
setting.
Sets the profile server operation mode. M
Adds an entry to the profile server client
list.
Removes an entry from the profile
server client list.
Displays the profile server client list.
Sets the target profile server IP address
for synchronization.
Synchronize with the profile server.
SHDSL profiles allow efficient
configuration of SHDSL port settings.
Removes an unreferenced SHDSL port
settings profile.
Displays which SHDSL ports reference
this profile.
Creates a profile of SHDSL port
settings.
<min-rate> = minimum rate,
192~4096 in Kbps
<max-rate> = maximum rate,
192~4096 in Kbps
annexa|annexb
= regional setting,
'annexb' by default
<wire-pair> = the number of wire
pairs to be used, '2wire' by default
lp_off = disable line probe, default line
probe mode
lp_on_cur = enable line probe with
current target snr margin
lp_on_wc = enable line probe with
worst case target snr margin
<curr-margin> = current condition
target snr margin, -10~21 in dB
<worst-margin>
= worse case
noise margin, -10~21 in dB
Chapter 16 Commands
P
L
M
L
L
M
M
L
M
M
M
L
M