ZyXEL Communications MSC1000G User Manual page 234

MSC1000G User's Guide
Table 102 Switch Port Setup (continued)
LABEL
Speed/Duplex
Flow Control
802.1p/802.1Q
Port
Default Priority
Default VLAN ID
[1-4094]
GVRP
Frame Type
VLAN Trunk
Bandwidth Control
[0~1000]
Port
Enable
Ingress Rate
Egress Rate
Broadcast Storm
Control [0~262143]
Port
Broadcast
234
DESCRIPTION
Select the type of Ethernet connection for this port. When you don't use auto-
negotiation, you must make sure that the settings of the peer Ethernet port are the
same in order to connect.
Select Auto (auto-negotiation) to have the system automatically determine the
type of connection that the Ethernet port has. When the peer Ethernet device has
auto-negotiation turned on, the system negotiates with the peer to determine the
connection speed. If the peer Ethernet port does not have auto-negotiation turned
on, the system determines the connection speed by detecting the signal on the
cable and using full duplex.
Select 1000/Full if the Ethernet port has a 1000 MB connection.
Select 100/Full if the Ethernet port has a 100 MB full-duplex electrical connection.
Select 100/Half if the Ethernet port has a 100 MB half-duplex electrical connection.
Select this check box to turn on flow control on a port.
Use this section of the screen to configure IEEE 802.1 p priority and IEEE 802.1q
VLAN settings for the Gigabit Ethernet interfaces.
This is the label of a Gigabit Ethernet interface.
Select a default priority to use for frames that come into the interface without a
IEEE 802.1p priority tag.
Select a default VLAN ID to use for frames that come into the interface without a
IEEE 802.1q VLAN ID.
Select this check box to turn on GARP VLAN Registration Protocol to have the
interface propagate VLAN information to other devices.
Clear the check box to not have the interface propagate VLAN information to other
devices.
Select all to have the interface accept all Ethernet frames. Select tag to have the
interface only accept frames with an IEEE 802.1Q VLAN tag.
Select this check box to have the interface use VLAN trunking in order to accept
frames with any VID.
Clear the check box to have the interface only accept frames with registered VIDs.
Use this section of the screen to configure bandwidth control settings for the
Gigabit Ethernet interfaces.
This is the label of a Gigabit Ethernet interface.
Select this check box to turn on bandwidth control for an interface.
Type a maximum bandwidth allowed for the incoming traffic flow on a port
(measured in megabits per second). Use a number from 0 to 1000.
Type a maximum bandwidth allowed for the out-going traffic flow on a port
(measured in megabits per second). Use a number from 0 to 1000.
Use this section of the screen to configure broadcast storm control settings for the
Gigabit Ethernet interfaces.
This is the label of a Gigabit Ethernet interface.
Select Enable to limit the number of broadcast packets the interface will accept
per second.
Type how many broadcast packets the interface should accept per second
(0~262143).
Chapter 13 Switch Screens