Profile Alarmshdsl Set Command - ZyXEL Communications MSC1000G User Manual

The following example displays the default alarm SHDSL profile (DEFVAL).
ras> profile alarmshdsl show DEFVAL
shdsl alarm profile : DEFVAL
loop attenuation(atten)
snr margin(snrmgn)
es
ses
crc anomalies(crc)
losws
uas
ras>

26.6.2 profile alarmshdsl set Command

Syntax:
<profile> [atten <atten>] [snrmgn <snrmgn>] [es <es>] [ses <ses>][crc
<crc>] [losws <losws>] [uas <uas>]
where
<profile>
<atten>
<snrmgn>
<ess>
<ses>
<crc>
<losws>
<uas>
This command configures SHDSL port alarm thresholds. The MSC sends an alarm trap and
generates a syslog entry when the thresholds of the alarm profile are exceeded.
Configure
alarmshdsl
to use them with specific SHDSL ports.
Chapter 26 profile Commands
(dB):
(dB):
(sec):
(sec):
:
(sec):
(sec):
= A name for the alarm profile (up to 31 ASCII characters).
= The permitted loop attenuation of a port, 0~127
= The permitted signal to noise ratio margin, 0~15.
= The number of Errored SecondS (0~900) that are permitted to
occur within 15 minutes.
= The number of Severely Errored Seconds (0~900) that are
permitted to occur within 15 minutes.
The number of Cyclic Redundancy Checking anomalies that
are permitted to occur within 15 minutes.
The number of Loss Of Sync Word Seconds (0~900) that are
permitted to occur within 15 minutes.
= The number of UnAvailable Seconds (0~900) that are permitted
to occur within 15 minutes.
profiles first and then use the
MSC1000G User's Guide
0
0
0
0
0
0
0
port shdsl alarmprof
command to
413