This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100
sysname> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
33.5 Enabling RSTP
Syntax:
snapping-tree [port-number]
To enable RSTP on a port. Enter
. The following example enables RSTP on port 17.
[ENTER]
sysname(config)# spanning-tree 17
sysname#
33.6 vdsl-port Command
Syntax:
vdsl-port <port-list> profilename <name-str>
where
<port-list>
<name-str>
This command sets the specified VDSL port(s) to use a VDSL profile. The following example
configures VDSL ports 1 to 5 to use the
sysname(config)# vdsl-port 1-5 profilename test
33.7 Configuration File Maintenance
This section shows you how to backup or restore the configuration file on the switch using
TFTP.
33.7.1 Backing up Configuration
Syntax:
copy running-config tftp <ip> <remote-file>
VES-1616F-3x Series User's Guide
.
spanning-tree
Selects the VDSL port(s) (port 1 to 16).
=
Specifies the name of the VDSL profile.
=
test
Chapter 33 Command Examples
followed by the port number and press
VDSL profile.
249