Port Copy Screen - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
Table 60 PPVC Setup: VLAN (continued)
LABEL
Registration
Tag
Apply
Cancel
The table in the bottom half of the screen lists the VLANs that the PVC is a member of.
Modify
Delete
Index
VPI / VC
VID
Registration
Tag
Select

10.14 Port Copy Screen

Click Port > Copy in the navigation panel to open the following screen. Use this screen to
copy DSL, VLAN and PVC settings from one DSL port to another DSL port or ports.
158
DESCRIPTION
Select join to have the port be a member of the specified VLAN.
Select leave to remove the port from the specified VLAN.
Select the check box to tag all frames that are transmitted out on this PPVC with
this VLAN group ID.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Click Modify to display the selected VLAN membership entry's settings in the
fields above so you can edit them.
Click Delete to remove the selected VLAN membership entry.
This is the number of the VLAN membership entry.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI). The VPI and VCI identify the channel.
This field displays the number of a VLAN (VLAN ID) of which this channel is a
member.
This field displays "fixed" to indicate that the port is a member of the specified
VLAN.
This field displays "V" if the line card is to tag all frames that are transmitted out on
this PPVC with this VLAN group ID. It displays "-" if the line card does not tag all
frames that are transmitted out on this PPVC with this VLAN group ID.
Select the radio button of a VLAN membership entry and then use the Modify
button or the Delete button.
Chapter 10 DSL Port Setup Screens