Figure 86 Shdsl Port Setup: Line Card; Figure 87 Copy; Table 53 Shdsl Port Setup: Line Card - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide

Figure 86 SHDSL Port Setup: Line Card

The following table describes the fields in this screen.

Table 53 SHDSL Port Setup: Line Card

LABEL
UP
Copy
Apply
Cancel
Port
Enable
Customer
Information
146
DESCRIPTION
Click this to return to the previous screen.
Do the following to copy settings from one DSL port to another DSL port or ports.
1. Use the Select column to choose a DSL port from which you want to copy
settings.
2. Click Copy to open the following screen.

Figure 87 Copy

3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to
copy the settings. Click Select All to mark all of the port check boxes or click
Select None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
These are the numbers of the DSL ports on the line card.
Select a check box in this column to turn on a port. Select the check box at the top
of the column to turn on all of the line card's ports.
Enter information to identify the subscriber connected to this DSL port. You can
use up to 31 printable ASCII characters (including spaces and hyphens).
Chapter 10 DSL Port Setup Screens