Switch Queuemap Commands - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
This command shows the queuing methods and/or priority weights of the Gigabit Ethernet
interfaces. This is an example.
ras> switch qschedule show
port algo_type wt0 wt1 wt2 wt3 wt4 wt5 wt6 wt7
---- --------- --- --- --- --- --- --- --- ---
sub1 spq
sub2 spq
up1 spq
up2 spq
ras>

28.12 switch queuemap Commands

Use these commands to set the priorities of the individual queues.
28.12.1 switch queuemap set Command
Syntax:
switch queuemap set <priority> <queue>
where
<priority>
<queue>
This command sets the MSC to use a particular queue for traffic of a specific IEEE 802.1p
priority.
The following example sets the MSC to use queue 3 for traffic with priority 3.
ras> switch queuemap set 3 3
28.12.2 switch queuemap show Command
Syntax:
switch queuemap show
This command shows which queue the MSC uses for traffic of each priority. The following is
an example.
484
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
= The IEEE 802.1p priority for each queue, 0~7.
= A physical queue in the MSC, 0~7.
0 0 0
0 0 0
0 0 0
0 0 0
Chapter 28 switch Commands