Port Shdsl Set Command - ZyXEL Communications MSC1000G User Manual

where
<mode>
This command sets the PMMS (Power Measurement Modulation Session) mode of the
specified SHDSL port(s).
The following example sets SHDSL port 8 on the line card in slot 6 to use the negotiated target
noise margin mode.
ras> port shdsl pmms 6-8 normal

25.11.4 port shdsl set Command

Syntax:
port shdsl set <slot-port> <profile>
where
<profile>
This command assigns a specific profile to an SHDSL port(s). The profile defines the
maximum and minimum transmission rates, the regional setting, the number of wire pairs to
be used, whether line-probing is enabled or disabled and the target and worst case noise
margins.
The following example sets SHDSL port 8 on the line card in slot 6 to use the gold profile.
ras> port shdsl set 6-8 gold
25.12 port show Command
Syntax:
port show <slot>|<slot-port>
Chapter 25 port Commands
= The PMMS (Power Measurement Modulation Session) mode
specifies how the target noise margin value is acquired.
= Negotiated target noise margin mode. Each end of
normal
the connection determines the target noise margin to be used by
the other end for the evaluation of the PMMS results.
Forced target noise margin mode. The upstream and
forced =
downstream parameters are set according to the target noise
margin value set in the SHDSL profile.
= The SHDSL profile that will define the settings of this port.
MSC1000G User's Guide
387